imported_paradigm
New member
I was very fortunate to win the September 4* Product giveaway by Danase and want to share my impressions of the products so far. I worked on a 2004 Honda Accord (dark red) this afternoon, and used the SMR and MCC products along w/ a 5" orange LC pad. I tried my best to keep the same angle for each pic for easy comparison.
Each after pic is following one (1) round with the MCC product. It finished to an LSP level w/ the orange pad...I was pretty surprised to say the least (I don't get that often w/ the other products I use). To make sure it was LSP ready and I wasn't missing out on an even better finish, I followed the MCC w/ a round of SMR and it looked the same...so the entire vehicle was done w/ MCC only. A few areas needed a second hit with the MCC, but not many.
Here is the rear passenger side quarter panel before/afters:
before...
afters...
here is a half and half (polished area to the left of the lights...unpolished in the lights...sorry for not marking it off w/ tape)...
trunk area:
before...
after...
fuel door area:
before...
after... (slight marring remained after this first pass)
Each after pic is following one (1) round with the MCC product. It finished to an LSP level w/ the orange pad...I was pretty surprised to say the least (I don't get that often w/ the other products I use). To make sure it was LSP ready and I wasn't missing out on an even better finish, I followed the MCC w/ a round of SMR and it looked the same...so the entire vehicle was done w/ MCC only. A few areas needed a second hit with the MCC, but not many.

Here is the rear passenger side quarter panel before/afters:
before...

afters...


here is a half and half (polished area to the left of the lights...unpolished in the lights...sorry for not marking it off w/ tape)...

trunk area:
before...

after...

fuel door area:
before...

after... (slight marring remained after this first pass)
