I like a few QD's, but for overall use and value I like Meguiars FI. It works good and it does not cost a ton of $$$. It's a good product, and at around $20/gallon it is very economical to use.
Like others, it's hard to pick a single one. I like the Clear Pearl for bringing out the richness, but Meguiar's Quick Detail spray is wonderful for removing bugs, etc.
Sometimes, I'll CP the whole car except for the front bumper where I'll use QD spray so that I can get rid of the insect carcases.
I played with Meguiars FI, Sonus Spritz, EF Clear Pearl, & Zaino 6 this weekend before I washed my truck to check them out. My truck has a bunch of Z on it and has been about 3 weeks since the last coat of Z2. I tested on vertical panels on my truck all on one side.
I must say they all cleaned well and apply and remove about the same. Not really a big enough difference to report. I sprayed on MT than wiped and buffed with other side.
As for slickness afterwards I rate as follows:
1- Z6 Tie with Sonus Spritz
3- EF CP
4- Meg. FI
The Sonus and Zaino were hard to tell apart. I did a blind sort of test. I QD then had un biased GF come out and feel the paint.
As for the shine they were all the same to my eyes and hers. It was bright and sunny out when we looked for shine.
I will save the Z6 for coating prior to any more Z coats.
I probably will use the FI for bugs and claying.
I will use the Sonus for a Weekly QD of the truck.
I will use CP in between or just save for when I am out of Sonus.
similar to Guess i use the Z6 around coats of Z and now pretty much Fi for anything else...i used to just use Z6 for it all but then it goes too quik.....
ps...never had an unbiased GF yet...they all hated that i spent too much time detailing...
Like Showroom Lincoln, I like Meguairs Final Inspection. I get it for about $18 a gallon (professional discount ), and since I go through a gallon in about 3 weeks, it is the best combination of value and quality I have found.
Wax Shop's Slick Stuff is also pretty good. I just got some BeadX from Formula 113, but really haven't used it enough to really compare it to the others yet. I want to try it in direct sunlight, since it says you can, and being mobile, I don't always have shade to work. I can use FI in sunlight as long as I work quickly.
I like the Meguiar's FI but also like their retail product called Quick Detailer. It smells great! It also has a very effective sprayer that sprays a nice fine mist. When I finish the QD I think I'll keep the bottle and fill it with FI from a gallon jug.
Short Cut-- I did the same thing. I found the "Quik Detailer" ($4-6) spray bottle to be much better than the Final Inspection bottles. I bought a gallon of FI and am using it in the Quik Detailer spray bottle with great results. It's a much finer mist than most other spray bottles, with good distribution.
Just make sure you get all of those nasty silicones out of the bottle
My goodness!!! I was shocked to see Meguiars FI with so many votes. I think many of those folks have yet to try some others. There are a lot of good choices out there!:up
which one buddy. the FI is about $20 at topfotheline. Someone recently left a link to a site they got it at for that. Maybe you can fine it in a search..
As a very active member of another Forum, I really hate it when the same question gets asked over and over again. So everytime I do go in a new forum, I use the search engine before posting. But since this forum is filled with abbreviations, and the search engine requires a 3 letter minimum to do a search, it is pretty difficult. Try doing a search on QD, or Meguiers FI, the search engine will not allow you to type that.:up
i try to trick it by spelling the whole thing out...anyway...here's a really good QD link...lots of opinions:up and is has FI in there...the gallon for about $20+shipping...