Your PC Pads

[TQB]

I was wandering if you dedicate a PC pad to a certain product or do you dedicate it to certain type of product? (ie .. this pad for EX-P only or this pad for sealents only)

 

[Beemerboy]

I don't I just make sure that they are cleaned after I get done with the detail. I'd bet that there are some that do use certain pads for certain products

 

[MobileFanatics]

same here unless I use the pad often for that product then I mark it on the back to use it only for that product, other than that, I just make sure the pad(s) are cleaned very good.

 

[Bob]

The pad I use depends on the product I am using and the paint condition.

 

[andriver]

Agree with 2001civicex. I use yellow and white pads with same products depending on the paint condition.

 

[ScreeminGTP]

What do you guys usually use when you are cleaning the pads off.

 

[Bob]

I just use a degreaser and make sure to rinse them off and that NO degreaser is left in the pad.

 

[awd330]

I normally dedicate one product per pad unless the products have very similar characteristics (e.g. SSR2 and SSR2.5). Even then, I will thoroughly wash the pad in between uses.

I handwash my pads in warm water with either Murphy Oil Soap or Dawn Dishwashing liquid. Air dry on a wire rack.

 

[typeSR2]

awd330 ot but is ssr 2.5 out yet? if not what is the eta on the release of it?

 

[zesty-man]

for now, ive gone one pads for every product. that means that each pad i own is designated for one, and only one product. i dont wanna get into that washing thing and stuff, in fear that i may do something wrong, and get some kinda chemical reaction on the paint (something typical of me to do)...

 

[awd330]

awd330 ot but is ssr 2.5 out yet? if not what is the eta on the release of it?

A few bottles of SSR2.5 have already been distributed. The estimated general release is within the next few days.

 

[danhimself520]

I dont have enough pads per seperate product, so im left per type of product.