What speed for Menzerna?

T

theflyingturtle

New member
Well I haven't been here for a while! There wasn't much point owning a roached out 18 year old Civic. The clearcoat failed on the roof and trunk yerars ago! The wife needed,and got, a new car so it is time to get back into the game. It is a candy white VW. It seems to like wax more than sealants. Regardless I am using Menzerna IP and micro polish. The IP I run at 5K rpm on the PC and it takes off the oxidation from sitting on the dealer's lot off. That's fine but I cannot remember what speed to use for the micro polish or what pad to use. I would assume that more speed=better but I really do not know. 4K rpm? Also, I wasn't sure of which pad to use, blue, which is a finishing pad or white, which is one step more agressive. Thanks.
 
If you are using a PC, life begins at speed 6 :).



White foam is a fine choice for your Micropolish again on speed 6, that way if you wanted to apply your wax/sealant you would have a blue pad left. The PC is so docile, that going from 70ppi white foam to 80-85ppi(pores per inch) blue foam is hardly a step down.
 
You must log in or register to reply here.
Back
Top