WG Sealant over...?

S

scottabir

New member
Ok in light of a recent and long 5 page thread going about WG sealant I thought I would start a new trhread rather than make people scroll through 5 pages of well not much information.



so here it goes: Just out of curiosity what have people used before applying WG...example Menzerna FP, #82, VM ect ect.?

Maybe some of us that have had bad experiences used a product not suitable to be underneath it?



Any inoput is greatly appreciated, I like the looks of this product from some of the pictures I have seen and would like to give it a fair shot on my car.

Thanks,

Scott
 
I have been useing the Wolfgang Prewax before the sealant and have had just great results. I have tryed a lot of sealants Blackfire,Zaino, Klasse just to name a few and I think the Wolfgang twins gives me the best results. I always keep shaking the bottle and put on a very thin layer of sealant. I cover the complete car then wipe it off with a microfiber towel .

Also Jason @ autogeek told me for best results not to put on the sealant late in the day if the car is going to sit outside. It takes a few hours for the sealant to set up and it should be in a dry area. So no washing til the next day and dampness,due,and rain will affect the outcome. Jason thanks for the info.:xyxthumbs
 
I asked this same ? a week ago and the recommendation was that AIO was the way to go. I will be trying it this weekend
 
The first time I tried WG, I polished with 1Z MP..then applied AIO with a finish pad at low speed..removed and applied WG Gloss. It looked amazing, but I thought I really didn't give WG a fair shake, so 2 weeks later, I re-polished with 1Z, then the WG Precleaner, then WG Gloss. Again it was very impressive...although I think I preferred the AIO treatment better. Very hard to say..I guess I just felt better knowing the AIO was underneath for protection. Both methods work well.
 
bmax said:


Also Jason @ autogeek told me for best results not to put on the sealant late in the day if the car is going to sit outside. It takes a few hours for the sealant to set up and it should be in a dry area. So no washing til the next day and dampness,due,and rain will affect the outcome. Jason thanks for the info.:xyxthumbs
Click to expand...



Interesting...I guess that's probably why I have gotten about 2 weeks of beading with WG. When I applied the sealant, it was pretty late. Will have to try a different time next time. Thanks!
 
I've had great luck applying the WG sealant after SSR1, SSR2, GPEC, and the WG polish.
 
You must log in or register to reply here.
Back
Top