I just wanted to post for everyone the 'issue' I am running into with VC wax. While the wax does look great, very warm, without much gloss. The other day I went outside to wash pollen/light sap off of the car. Normal spring-time in NE type stuff.
Well, I used 1Z Glanze last year, and expected it to be similar. However, I was severly mistaken! The VC wax after being washed with Adams Car wash, and a australian wool mit with two bucket method was just pathetic. It would not clean up and sheet water the way it should if it had released the tree sap that was on top of the wax. So instead of it sheeting water nicely, it just continued to have the dollops of water sitting in pools of tree sap.
I had to go from the wool mit, to the MF and apply the wash 3-4 x to get any good 'sheeting'. I then decided this wax was not good for a DD and applied a layer of 1z Glanz, as the one panel that did have 1z Glanz, cleaned up with one application of wool mit and 1 application of MF washing.
Just wanted to post my feedback, as LSP selection is at the front of everyones mind right now.
Well, I used 1Z Glanze last year, and expected it to be similar. However, I was severly mistaken! The VC wax after being washed with Adams Car wash, and a australian wool mit with two bucket method was just pathetic. It would not clean up and sheet water the way it should if it had released the tree sap that was on top of the wax. So instead of it sheeting water nicely, it just continued to have the dollops of water sitting in pools of tree sap.
I had to go from the wool mit, to the MF and apply the wash 3-4 x to get any good 'sheeting'. I then decided this wax was not good for a DD and applied a layer of 1z Glanz, as the one panel that did have 1z Glanz, cleaned up with one application of wool mit and 1 application of MF washing.
Just wanted to post my feedback, as LSP selection is at the front of everyones mind right now.