Uno help

B

broncoupe

New member
I need help i read plenty about Uno and tried it, the results were great by hand using a foam pad terrible with a DA...in my hands

I have the new Meg V2 or Das Pro6 also have the Mak 6020 find it a bit heavy and a lot of vibration to your wrist

I use a 3m yellow pad but i also have the harder green pad what happens is i dont get the amount of cut i expect, and the pad doesant seem to dry out. Which makes me think i am using too much is there a good instruction video, i am just struggling

I want the results you guys get

mike
 
Use just 3 small drops at first then 2 from there on out. I have used it with great success using the Meguiars Micro Fiber cutting disc and have used it as a medium/finish polish with foam pads. Make sure the work area is no bigger then 18"x18" slow arm speeds and some pressure
 
sal329 said:
Use just 3 small drops at first then 2 from there on out. I have used it with great success using the Meguiars Micro Fiber cutting disc and have used it as a medium/finish polish with foam pads. Make sure the work area is no bigger then 18"x18" slow arm speeds and some pressure
Click to expand...



3 drops after priming the pad?
 
I find a primed pad can do more than 2-3 times an area that a regular polish can do. It goes sooooo far. Even when the pad looks dry, you can still see it lubricating the surface. Just add a couple of drops to the pad if the cutting action drops off.
 
You must log in or register to reply here.
Back
Top