The BF "trifecta"

glen e

Retired Geezer
The BF "trifecta" - the 50 minute detail

Decided to see how good my new BF stuff really does, so I did a quick exterior detail early this morning on my DD. So here's the procedure:
1. completely wash with Dawn, then washed again with BF Conditioning shampoo. Car clayed a week or two ago
2. dried and used a GG6 with grey pad to apply TPnS - lightly - no real hard polishing
3. Used BF Polymer spray to remove haze and quick buff.

I was really happy it does not stain trim with white dust at all, and comes off real easy. As a mater of fact, when you are cleaning it up with the spray, you don't feel any pull of the haze on your MF. My first rule of detailing is EASY AND QUICK - and this fullfilled that - from start to finish in 50 minutes...

This is in my garage so it cures a bit - cloudy/rainy here - this is about 30 min after so I'm expecting more gloss as we go thru the day. The best way to show this is by how much the reflection is deep and this is cheap 3 yr old Honda clearcoat and paint.
4ed21938.jpg

a5e74778.jpg


ba967873.jpg


Todd - I have left the trunklid completely bare with just the Dawn wash. When I get the CS, I'll divide the trunk and on one side do Ultima prep and UPGP, and the other, TPns and CS....stay tuned!
 
Awsome job Glen but I do have to say I like the ceiling reflection better than the other one:eek:
 
50 minutes? Holy cow! I need to trim my time down a bit. I'm still drying the car at 50 min LOL!

Nice Job! I am looking for a TPnS victim this weekend. Maybe my car :D
 
50 minutes? Holy cow! I need to trim my time down a bit. I'm still drying the car at 50 min LOL!

Nice Job! I am looking for a TPnS victim this weekend. Maybe my car :D

It really could have been shorter and I think this is the break thru of this stuff. You effectively eliminate the entire buff off/q-tip manicure procedure of dusting and getting the white power out of jambs, etc. AND get a polish. I washed twice just to make sure all my other stuff was off and you could eliminate 5 min by starting just with the BF wash. The other thing that makes it fast is the TPnS goes on with a lubricity that allows the GG6 to move quickly over the panels...

I love how this industry is going: (times may be wrong but just for example)
5 yrs ago: polymers, but still dusting...
2 yrs ago: polymers that WOWA
now: polish and polymers WOWA
 
Trifecta on the boat too - note this is paint, not gelcoat - the reflection is from 15 feet away and are the boards in the dock - marine whiplash:
baffb3b7.jpg

0b2c8ae5.jpg
 
Back
Top