swirl removal analysis

I

imported_tuffluck

New member
this is after DACP by HAND, #9, 2 coats of tech wax, a coat of mother's natural carnuba, and a 500 mile road trip. suggestions on removing what can be seen in the picture will be appreciated...



swirl.JPG
 
i guess your still having this problem..... menzerna IP is what you need. i dont think youll be able to remove these by hand you may be able to hide them.. i sent ya PM on ls1tech dont know if you got it or not..
 
6']['9 said:
i guess your still having this problem..... menzerna IP is what you need. i dont think youll be able to remove these by hand you may be able to hide them.. i sent ya PM on ls1tech dont know if you got it or not..
Click to expand...



i did get it :) i will let you know in the future what i plan on doing. right now it's bothering me almost too much to put any more effort into it, haha. thanks for all of your help. i could swear the DACP would be able to take those swirls out though...
 
btw you dont have to pay for anything, just incase you misread it im offering to let you use what i have. to see what it is you really need cause your gonna go crazy buying smr's you may or may not need
 
that's cool. i actually assumed you meant i could try anything i wanted for free, and then just buy what i like of those products. i do appreciate it. i'm not a big fan of long drives in my car, and especially not in sa. i had a bad experience there recently, and everytime i drive south on 35, it haunts me. so maybe in the future. for now i'm just sick of messing with it, but would still like an explanation. i'm sure you know the feeling :)
 
I have that exact same problem!! So should I use Menzerna IP to take care of those swirls. Will I need to buy a PC to take them off or can I take them out by hand? I don't have the money to buy a PC maybe I should just hold off until I can.
 
DACP with hand - best to mash hard on the terry cloth and go fast? or just go fast in smal spots, so as to get the friction level high? i don't really know, so this damage might be because i didn't do the DACP right.
 
Ya, you really have to work the DACP REALLY hard, so it breaks it down. Just go for about 2 minutes in a 2x2 section, and press really hard, and use the terry side of the applicator.
 
DACP takes long even for a PC. You need to work it until it breaks down to a fine powder practically.
 
man..... if you've got all day and you're as quick as the flash tnen you'll be able to take those swirls out with DACP. You really need to get that PC or DeWalt. Just like the guys here mentinoed... it's gotta break down in order for it to work properly and by hand that's gonna take some time.
 
You must log in or register to reply here.
Back
Top