Rotart MIN rpm ?

O

Oni

New member
Hi im a long time lurker and i just got myself a rotary buffer. i wanted an orbital but after 2 weeks of looking i was unable to locate a store/ website that i could get one off for under $300 ( with postage i live in tasmania, AUS). Im guessing that the slowest speed you can effectivly use is a speed that still breaks down the polish, in general could someone recoment a good starting rpm that should beeak down most Maguires Polishes? ( again all i can get locally ). Thanks in advance i have a scrap car to practice on so it will all be fun and games :)



Thanks
 
1000 RPM is great for spreading, and working milder polishes that don't require heat to break down.



1200-1300 RPM is a good speed to start with the heavier compounds, you'll move up to 1500-1700 as your comfort level increases.
 
I find using the lowest 600 rpm with my makita quite often spreading the polish at first and on final stages working the polish.
 
Thanks for the quick replies. thanks holden ill be sure to read through that!. ive looked at all the guides here and picked up some tips. im always hazardous about trying tips from other sites as ive had bad advice before.Thanks for recomending it. Ill get some Polishing pads aswell thanks :)
 
You must log in or register to reply here.
Back
Top