Removal of too much LSP

I

imported_Detailing Technology

New member
What are you using to successfully remove too much LSP? At 3 feet in the direct sun, the finish looks immaculate, when I pull in to 1 foot, I notice that oily presence associated with too much LSP.

I tried Z-8, Z-6, FK1 425, Water, alcohol / Water mix, and ONR. Nothing works 100%. I also tried a Pakshak Ultra smooth microfiber, then a Ultra-soft waffle weave.



No luck. Process? Products?
 
I just use a standard microfiber and prep-sol. The downside of this process is that it won't just remove the excess LSP, it will remove all of it and you will have to reapply. That option is still better than leaving the excess on however.



Another possible solution is reapplying the LSP to the area and before it hazes start to remove it. The solvents typically used to keep it suspended in a useable state could help to remove the excess that is underneath it. I haven't tried that method personally, but I have heard that suggested as a means of removing the excess previously.
 
True. I needed a reminder, I could reapply and remove before the hazing.



Its Z-5pro. I used WAY too much yesterday in a rush. About 1 full ounce for a Jeep Grand Cherokee. Ill warm up some Z-5pro with no ZFX and give it a go again.
 
You must log in or register to reply here.
Back
Top