Blackmirror
New member
What about Menzerna Final Polish?
Ready to use DACP
- Thread starter Blackmirror
- Start date
JasonD
New member
That would work. Check your PM
imported_rusty bumper
New member
I wouldn't use a PC on the 6 setting myself...I think you are much better off using it on the 5 setting with DACP.
Press down on the PC just enough until the motor starts to bog down a little, and keep buffing until the product begins to disappear...But don't buff it dry.
Press down on the PC just enough until the motor starts to bog down a little, and keep buffing until the product begins to disappear...But don't buff it dry.
Blackmirror
New member
Good replies guys!:up
What about using DACP(with PC of course) on the edges of the fenders, doors, hood, etc.? Should I do those areas by hand or is it ok to go over those areas with the PC?
Here's the plan I'm going to use next time:
Yellow pad and DACP on bad areas
White pad on less bad areas
Menzerna FP with white pad
AIO with white pad
SG by hand
What about using DACP(with PC of course) on the edges of the fenders, doors, hood, etc.? Should I do those areas by hand or is it ok to go over those areas with the PC?
Here's the plan I'm going to use next time:
Yellow pad and DACP on bad areas
White pad on less bad areas
Menzerna FP with white pad
AIO with white pad
SG by hand
JasonD
New member
You shouldn't have a problem with the PC, just don't concentrate on those areas for any length of time. Keep it moving nice and slow. A rotary would be a totally different story.