Ready For Some VM/EX

Wasatch

Wasatch

New member
I'm going to do a detail of VM/EX combo. Was going to apply the VM with a MF applicator and EX with a foam applicator. VM applied panel at a time, then wipe off with MF. EX same. This is my first time with these products. If anyone could give me some tips I would appreciate it.
 
do you have a pc? if not then your technique sounds good. Just apply the EX very thin cause its kinda thick. Let the EX sit then remove after about 30 minutes. Ive noticed that it does add more pop when you let it sit for a while. good luck & post pics when your done
 
VM topped with EX is my favorite (rignth now at least) combo on black. Work the VM in well and it will leave a deep wet look. As 69 said, the Ex needs to be laid down as thin as you can, let sit for at least 30 minutes. Use a QD to get off any small amount of dusting you may get and then stand back and admirer the shine.
 
Thanks for the tips. No PC yet. I guess I'll do the whole X with the EX then remove first section after 30 mins.
 
You must log in or register to reply here.
Back
Top