Polish for Rejuvenating Bright Red

Eliot Ness said:
On your pads, you should figure at least one pad for each product you’re going to use. So looking at your product list you’ll need:



IP: polish pad

FP: polish pad

AIO: polish pad

NXT: polish or finish pad

SG: usually applied by hand

Still thinking about the topper: if the topper is applied with the PC then another finish pad.



Add in a cutting pad if needed for more severe defects.
Click to expand...



OK, that's good to know. So...the question is, where can I order polishing pads and MF's by the bushel?:xyxthumbs



Also, I assume these pads are re-usable. Hand or machine wash? Typically how many uses can you get out of each pad?
 
Oh...and very nice reds SpoiledMan and Elliot Ness:xyxthumbs



Seems like that Vanilla Moose Product is quite popular around here. Might have to pick some of that up as well ;)
 
Thanks texax328ci. That was my first use of VM and I was VERY impressed! I bought 2 quarts right after that so I wont run out anytime soon.
 
texas328ci said:
OK, that's good to know. So...the question is, where can I order polishing pads and MF's by the bushel?:xyxthumbs



Also, I assume these pads are re-usable. Hand or machine wash? Typically how many uses can you get out of each pad?
Click to expand...

David sells both the LC and Sonus pad kits here on Autopia. You can order a kit and then the extra pads you may need. If you order Sonus pads enter the code SONUS for a 15% discount: http://store.yahoo.com/autopia/pcdepot.html



I wash my pads in a bucket with dawn. You should get a lot of use out of a pad before it wears out/breaks down.



Here is a good basic guide to using the PC, washing pads, etc.: http://store.yahoo.com/autopia/inf-pc7424.html



Here are two good sites for MF's:

http://www.exceldetail.com/



http://www.pakshak.com/



If you order from Pakshak e-mail him first about prices for Autopia members, there is a very hefty discount.
 
I also have a red car with a bit of oxidation and alot of swirls and holograms. Im thinking of going out any buying a PC and using some 3M III MG + Meguiars #7 + S100. Anyone think that would provide a very wet shine?



Im very tempted to buy the PC right now hehe.
 
You must log in or register to reply here.
Back
Top