Optimum Poli-Seal - clumps?

[imported_Detailing Technology]

I used Poli-Seal after Meguiars M205 today. I applied the Poli-Seal with a PC and back LC CCS pad.





SUPER CLOSE-UP (yes, those are the metallic flakes)

I see small clumps like this in some areas. They aren't easy to remove. I tried ONR and then finally IPA to get them off.



Any ideas why this happened and how to fix in the future?

 

[Chris@Optimum]

looks like the speed may have been too fast and/or too much PS. If PS was your only LSP, you need to hit the spots you IPA'd again.

 

[imported_Detailing Technology]

Good call - I was at 6 on the PC.

 

[imported_Detailing Technology]

Optimum has an impressive shine and slick feel.



I'm impressed with Poli-Seal, Optimun Car Wax, and Opit-Seal. Got to try the rubber products.

 

[Scottwax]

Sometimes with a little too much pressure, too much Poli-Seal and some heat, it clumps like that on the paint. I usually add a touch more to the pad and go over the area again, or use a foam hand pad with a little OPS on it to remove the clump. Not sure why it does that but once I got the hang of using it, I very rarely have that happen.