Need to remove 2000 grit marks with PC

S

Shane

New member
After wet sanding with 2000 grit to level some of the orange peel in a fresh paint job, I've had limited success at removing the sanding marks. I've tried wolfgang total swirl remover and some 3M swirl remover to no avail. Well, the majority of the marks are gone, but in sunlight many are still visible.



Poorboy's SSR3 was recommended, but after reading one review it seems it may not be the product for me. (too much hazing etc)



Here are the products I currently have.



Orange and white pads (light cut and polish).

WG Swirl remover

WG Finishing glaze

WG Gloss sealant

Klasse AIO

S100



Menzerna sounds like the way to go, but I usually order from Autogeek as the products arrive the next day.



Any suggestions are greatly appreciated. FYI, this is on a Merlot Mica (dark metallic wine color).
 
I would also suggest SSR3, or possibly SSR2.5 with an orange pad. In order to remove sanding marks, you're going to need a strong compound and cutting pad, so don't expect to have a haze-free finish right away. You'll need to follow up again with a light polish.
 
your not going to be able to get out sanding marks and not leave some hazing behind. I'd just get the SSR3 and then follow up with a lighter polish (I think SSR1 will be able to get out the hazing).
 
2 passes of SSR2.5 with polishing pad applied by DA has worked for me pretty much every time.
 
You must log in or register to reply here.
Back
Top