Need help. Light problem

WEST 014

New member
I have problem, I do not know anything about lighting. I would like someone to help me to find best light source to detect swirl marks & holograms. Here do not sales Sun - Guns. What is the solution of my problem? But only if it is not too expensive for me. Regards
 
1. Infratech CM5300 – Colour Matcher - this light is a great alternative to the 3M Sun Gun. Runs on mains electricity not batteries, a must have tool and it’s also an inexpensive investment. High Colour Temperature 5300K Duplicates Natural sunlight under any condition, high power 70 Watts, large coverage area, hand held lightweight, momentary "On/Off" switch, identify pre-or-post paint correction / renovation defects, eliminate re-doing or call-backs (150 USD) – http://www.detailersdomain.com/lighting.aspx



2. Fenix Gear TK11 R2 - a powerful, solid, durable, and waterproof design, which can use either two CR123A batteries (primary or li-ion) or one rechargeable 18650 battery with a protective circuit, and it maintains excellent constant brightness with two output modes. This TK11 features Cree's new R2 LED, which boasts better efficiency for higher output per mode. Digitally regulated output - maintains constant brightness (100 USD)



3. The Fenix TK45 flashlight features three lighting heads with an output of 760 lumens, utilizing three Cree CP-5 R5LED, which are. Energy efficient lamps (100 USD)




Prices shown are approx only
 
Back
Top