autoconcierge
New member
Recently completed jobin the shop, this new vehicle was in good shape but needed a little work to be optimized and protected as the owner will take the car to the track. Had Daniel from Car Connoisseur in on this one as well and here we are during the wash phase of the job.
Brought inside, the vehicle was dried off and a metro blower used to get the water out of all crevices(Even though a CR Spotless was used).
Daniel handling interior and engine bay clean up duties.
All exterior surfaces had been wrapped except the carbon wing, sand scratch cluster.
Defects removed.
Underside of the wing being corrected.
Had Paul from "Attention to Detail" in Vancouver Washington down for advanced paint correction & detail training with Kevin Brown and myself, lending a helping hand on this rare vehicle(75 coming to the US according to the owner).
The three of us converging on the rear of the car.
Engine needed little, but this power plant HAD to be shown.
A few interior pics.
Flush mount carbon frame, finishing of the rear of the car right.
Gorgeous OE wheel.
Brought inside, the vehicle was dried off and a metro blower used to get the water out of all crevices(Even though a CR Spotless was used).
Daniel handling interior and engine bay clean up duties.
All exterior surfaces had been wrapped except the carbon wing, sand scratch cluster.
Defects removed.
Underside of the wing being corrected.
Had Paul from "Attention to Detail" in Vancouver Washington down for advanced paint correction & detail training with Kevin Brown and myself, lending a helping hand on this rare vehicle(75 coming to the US according to the owner).
The three of us converging on the rear of the car.
Engine needed little, but this power plant HAD to be shown.
A few interior pics.
Flush mount carbon frame, finishing of the rear of the car right.
Gorgeous OE wheel.
