Menz PG vs. M105?

clnfrk

New member
Just curious how the two compare in terms of correcting ability? I'm guessing the M105 finishes better? I have the PG, but have never tried the M105.
 
from what ive read M105 completely destroys menz powergloss in EVERY department. Works faster, finishes almost LSP ready and corrects deeper defects.
 
Carbon Blue said:
from what ive read M105 completely destroys menz powergloss in EVERY department. Works faster, finishes almost LSP ready and corrects deeper defects.



This would be my experience...



On an sanded area on Porsche 997, PG took 3 applications (at about 30 seconds per application) to remove the marks and bring the gloss up, where took one pass at about 10 seconds. So M105 finished the same amount of work in 1/9 the time.



Also, PG left a finish that required a middle step before going to final polish where as M105 was able to eliminate the middle step, saving another 90 seconds or so...



So from start to finish, M105 did the work of 3 passes of PG and 1 pass of SIP in 1/18th the time. Its not really close IMO.
 
Haven't tried M105, but another thing against PG is that it dusts... a lot.



M105 sounds very impressive, but I'm a little worried that it might be easy to remove to much clear with that much cutting power, e.g. when overlapping from section to section.
 
SuperBee364 said:
If you would like me to get you a quart (or a gallon) and send it up to ya, Picus, just say the word.



Mr. Bee, you are, as they say, the man. Where do you order it from? Odds are I'll go for a gallon. Lord knows I'll use it. :D
 
Picus said:
Mr. Bee, you are, as they say, the man. Where do you order it from? Odds are I'll go for a gallon. Lord knows I'll use it. :D



From these guys: Meguiars Ultra Cut Compound



Say the word, and I'll get it on it's way here. I get stuff from them in only two days by UPS. I should have it here Wednesday if I order it tomorrow.
 
Back
Top