LSP bonding question and the myth of the lsp

P

Pixel

New member
I'm getting my detailing protocol pretty well under control. I've found a handful of products that I really like, but like most of us, I can't resist trying "something new" or a different combination of the old. So here's the question:



I'm confused by what "goes" with a certain types of LSP and what doesn't. For instance, my driver >>had<< PB EX-P as its lsp, until I felt the need to warm up the shine with Carnauba wax (so now that's the lsp). I understand that now, I >>can't<< add additional layers of EX-P. I >>assume<< that's because the polymer won't bond to the wax. But why? The wax stuck to the polymer!



To add to the confusion, I'm always touching up with a quick detailer. I've tried Aquawax (polymer, but didn't seem to have a problem) and EO wipe N Shine. So, is THAT now the lsp? What can go on that?



When does the madness end?!



What I'd love to have someone provide me is a mnemonic about what can go on top of what - in general terms - and what can't. I'd be a plus if I understood why as well.
 
I had a fellow Autopian advise me that I could top Aquawax with EX. Then when I asked about it at Poorboysworld, I was told that the EX would not bond on top of the AW unless I applied it via PC which would then strip the AW and allow bonding. I'm just as confused as you are.
 
from what i understand it has to do with the amount of petorleum distilates in the waxes and sealants.



if they have to many PD's they will likely affect the durability of the lsp.
 
Usually waxes over sealants (polymers, arcrylics) will work, but some sealants can go over the waxes (usually within the same family).
 
my rule of thumb is that sealants like a *clean* surface. Aka wax/glaze-free. waxes can go over anything.



i haven't had problems using that thus far
 
You must log in or register to reply here.
Back
Top