is your vehicle winter ready?

[skibik]

How is the beading and sheeting with this stuff?

Beading is good. Water sheeting not so good when it sprinkles, it just beads up, but the harder it rains the better it sheds. Water rolls off the car pretty good at anything above 25 MPH though.

Had good luck with that a few years back. Found it easier to work with that 476

I found that if you let FK1000P fully cure it is a bear to take off, reminiscent of the old green can of Turtle Wax hard shell when I was a younger. I used it last winter and it seemed to last a good 4 months or more through our salty winter. I had put on 3 coats, 2 the same weekend and a 3rd about 2 or 3 weeks later. Washed about every 2 weeks at a car wash when it was warm enough.

Dean.

 

[PA DETAILER]

:snow:
its around the corner........

 

[skibik]

:snow:
its around the corner........

We have been around that corner already here in NW MN already. Last weekend woke up to white on the ground for 3 days but it disappears though. Ground is not froze yet so the light snow falls are melting away. Warmest temp in the last 2 weeks was yesterday at a whopping 48F otherwise it had only been in the 30's for highs. Brrrrrrrr! Too early for that yet!

Dean.

 

[jtford95]

I have got nothing done. Soon. It needs a full detail. Inside and out.
I will compound it with Ardex's Smart cut. Polish it out with there Stereo glaze #2, & not sure about the slp. Any of this combo could change.... Want to use up some older product. Make room for new.