interior detail only....2002 Chevy 2500

I.A.S.

New member
a few befores...



PA120014.jpg


PA120015.jpg


PA120016.jpg


PA120017.jpg


PA120018.jpg




and some after shots...



PA120019.jpg


PA120020.jpg


PA120021.jpg


PA120022.jpg






carpets and seats were scrubbed with Cyclo w/ carpet brushes and all purpose cleaner....

dash and plastics were cleaned and dressed dressed..
 
is there a write up on how to detail carpet like that? i know you're using some kind of machine tahts called a "extracter"? i'm not sure. is there a write up that i can check out? where can i get more info how detailing carpet?
 
Most detailers use either a Bissel Little Green or a wet/dry shop vac to extract. Some use the Cyclone to really agitate the dirt.
 
gopedhead said:
is there a write up on how to detail carpet like that? i know you're using some kind of machine tahts called a "extracter"? i'm not sure. is there a write up that i can check out? where can i get more info how detailing carpet?



not much of a real process goin on....basically i sprayed all prpose cleaner (14:1) all over the carpets...then agitated with Cyclo carpet brushes, this only took like 5 minutes!...the Cyclo will do alot of work for you with minimal effort and in a short period of time...



But after i hit it with the cyclo I just went ahead and did a hot water extraction....



prtetty easy and straight forward IMO....nuthin special goin on....
 
well a Cyclo is a polisher but you can get carpet brushes for it.....a Cyclo you can get at any detailing website i beleive.....as far as an extractor goes i am not sure?....mine is custom made to run off my pressure washer with a water heater in the middle and it gets hooked up my vacuum system..
 
Very nice work! I use my Cyclo the same way in truck interiors (more room for it than in cars) and I'm going to get my other PC fixed and then attach one of the scrubbers to it for tight spots. :)



Really good way to deep scrub the carpets and mats.
 
Back
Top