I made spider webs! HELP!

K

koolmoecraig

New member
I clay barred.



I did Klasse AIO.



I did two coats of Klasse SG.



Everything looked GREAT until I put on my final PS21s wax. Now the hood looks like I did a bad buff job! Spider webbing everywhere!



What did I do wrong and how do I fix it? Every coat was given 24 hours to cure.



HELP!
 
In between your coats did you do anything prior to applying the next coat? Maybe something was caught in your applicator which induced the marring.
 
either the marring was there the whole time (most likely) and you just noticed it in different lighting...or the applicator/towels on one of the steps were contaminated.
 
I'm not sure where you are located but with winter coming up I would wait until spring to do any correction as it will probably be going through rough weather ahead...
 
Any pics?



My guess is the spider webbing was already there. None of your steps would have removed them, now with the candy coating of the SG they are accentuated :nixweiss
 
I live in So Cal so it's not really headed for anything too rough.



I think I might have accidentally used a towel that we used to remove the SG the day before.



Would that explain it? Any ideas of how to lessen the effect?



Thanks.
 
the only way to get them out is to polish them



maybe you can put some kind of filler wax on them top that with a sealant?
 
I'd bet the first few products you put on covered them up, then you put on a final product that wiped it off revealing the swirls again.



Just a guess. You cannot induce swirls by hand with clean materials unless you're using extremely abrasive product and rubbing in the same spot over and over.
 
You must log in or register to reply here.
Back
Top