How should i dry my pads in a hurry?

After each panel, I'll turn my PC upside down on my knee and take a cheap infant toothbrush and start the PC. I'll run the brush from the edge to the center several times and as long as I don't press in too hard on the pad, it keeps spinning and gets a bunch of dust ut of the pad. Plus, an added benefit is that much of the polish reside stays on the toothbrush bristles which makes it easier to get whiter teeth when I brush my teeth again.



JUST KIDDING! :)
 
tstead said:
After each panel, I'll turn my PC upside down on my knee and take a cheap infant toothbrush and start the PC. I'll run the brush from the edge to the center several times and as long as I don't press in too hard on the pad, it keeps spinning and gets a bunch of dust ut of the pad. Plus, an added benefit is that much of the polish reside stays on the toothbrush bristles which makes it easier to get whiter teeth when I brush my teeth again.



JUST KIDDING! :)
Click to expand...



That's interesting. I'll keep that in mind when I polish out my car soon :)
 
Just get all the water out of them you can then put them on the PC. Ive never had a problem doing so and all the water is out of them within secs.. I do it all the time with NO problems.. :)
 
I use one of those spur tools to clean the pad up if too much polish gets caked on it. Works pretty good. But i also keep a ton of pads around just in case. You can never have enough pads or mf towels.
 
You must log in or register to reply here.
Back
Top