Say I detail a vehicle using ssr1. I then get caught up with something else where I'm not able to work on the vehicle for a couple of days. It's rained and the vehicle has been outside. Can I just re-wash the vehicle and apply a coat of EX or do I have to start all over because the ssr1 has lost it's punch?
how long will ssr1 last without a sealant
- Thread starter III
- Start date
Bob
New member
I hate leaving my paint unselaed /waxed. I mean EX or Natty's takes freaking 15 minutes to do tops so just do it asap.
Woob
New member
You polished it so nothing was left behind. Rewash and seal it. How do you take off EX so fast? buff on off? I wait 45 mins and its easier than applying
Bob
New member
With EX? I usually buff on wait 10 minutes and buff off. I have doen everything from leaving it sit for 24 hours to not letting it sit at all and I can not tell a difference.
edschwab1
New member
If you cannot finish, I would just re-wash and apply EX. As already stated, try to finish and protect the surface. I thought SSR 1 was an abrasive, albeit a very mild one and not a glaze. Therefore SSR 1 should loose its punch.
Eric
Eric