holograms

I

imported_lennster

New member
I buffed my new tundra sunday with my old rotary and wool pad Sunday. Today is

the first day we had sun in a week. Leaving work i noticed Holograms every where.

Been a long time since i used it, and went against my better judgement. Need some

suggestions what's the best product to use to remove them, Gonna order a PC tonight

online.Need some help thanks
 
use a mildly abrassive polish, or a finishing polish. make sure to use a finishing pad as well. did the wool remove the marring you wanted removed?
 
I'm stupid .... My finish was good its 1month old I shouldn't have buffed with the rotary.

been a long time since i used it. Gonna have to buy some stuff on line tonight, my

local stores don't have any quality product here. I put em in now i gotta take em out

--it. searching e-bay for a PC7424 now and pads....suggestions???????
 
What product did you use to install the holograms?



There are so many choices out there. Lots of people will have their favorites.



Do you have any other products on the shelf, or is ordering a must?
 
its not the rotary, its the wool pad that caused the buffer trails...clean it up with optimum polish and an white LC pad, or megs 83, then 80, then wax
 
D&D..... I guess cause I'm a dumb a_ _... Just figured I'd try it. Gonna order a PC7424

and get some pads. It seems like most use LC pads here. What would be the proper

technique with the PC to remove them, don't want to inflict more damage
 
lennster said:
D&D..... I guess cause I'm a dumb a_ _... Just figured I'd try it. Gonna order a PC7424

and get some pads. It seems like most use LC pads here. What would be the proper

technique with the PC to remove them, don't want to inflict more damage
Click to expand...



Before you do that (and if you don't want to stick with your rotary), note that there is a new machine developed by and available through this site called the UDM which is a PC with a more powerful motor. You might want to consider.
 
Yeah, I'd much rather get a UDM than a PC now that the choice is there.



What product will depend on how bad the holograms are...my suggestion probably won't help much because what I like is discontinued and getting hard to find (3M PI-III RC 05933 followed by PI-III MG 05937). I suppose I'd say Menzerna IP followed by FPII or maybe one of their new polishes for scratch-resistant clear.



But if they're really bad I'd do a foam pad pass with the rotary first to get them a bit more manageable.
 
I been thinking bout the UDM also,if the sun shines tomorrow I'll try to take some

pictures to post. Then maybe ya'll can give me some tips as to removal.

If it ever stops raining.
 
You must log in or register to reply here.
Back
Top