Go to Spray Bottles for Spray Sealants...Hydro2

M

mobiledynamics

New member
Used plenty of Hydro2 on wheels.

1st time using it on paint today. Not crazed about how the Tolco CR sprayers go with this product....
What`s your preferred sprayer for Hydro2 ?
 
I like the Kwazar trigger, kwazar pump up is my favorite as the pressure gets the mist very fine, saving product and giving me the same application / protection.
 
Those are the ones I use. I barely squeeze the trigger to lay down a super fine layer of Hydro2.

meguiar-s-detailer-line-chemical-resistant-sprayer-4.jpg
 
I use the Tolco for super fine but kwazar when I use alot of product, like apc soaking. I find the Tolco is a finer mist an uses less but is definitely rougher on the hands over time.

Side note, Ray and Jeff have 1000 posts difference, exactly, weird.
 
I just googled this to see if there was any more.....I have these CR bottles that have dip tubes that are slightly bent on the end.
Anyhow, anyhoo...it`s subtle, but the mist on these are nicer than the Tolco`s. Guess I need to swap bottles.

I have the pump sprayers. YEARS ago, before Kwazer was the hotness, I came across these and they were made in Germany.
Bought a couple - but they are kinda big and heavy (walls/material of bottle is top notch).
I keep 3 bottles on hand - APC and 2 bottles which SEE no action - P21S Wheel and P21S TAW. I do use the TAW for engine bays, and I`m slowly using up my P21 Wheel.....
 
You must log in or register to reply here.
Back
Top