black-mamba
New member
How would you know if you went thru your vehicle's clear-coat?
Navigation
Install the app
How to install the app on iOS
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
More options
Style variation
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Clear-coat question
- Thread starter black-mamba
- Start date
imported_DetailDan
New member
It turns into kind of a cloudy color. Post a picture.
imported_DetailDan
New member
A CARS clear coat? You posted in the Marine section. Itll turn cloudy, post a picture.
In regards to that question I noticed on my driver and passenger doors there is some blotchy marks if I look at it from a different angle it looks cloudy but up close it seems to be normal could I have went thru the clear-coat? I used a PC 7424 with a orange on pad on speed 5 & 6 and some Adams swirl&haze remover that's about it.
around the sunlight you can see what looks like I guess micro-marring correct me if I'm wrong. Also is it true that when paint shows on the pad you gone thru the CC?
around the sunlight you can see what looks like I guess micro-marring correct me if I'm wrong. Also is it true that when paint shows on the pad you gone thru the CC?
imported_Detailing Technology
New member
I dont see it. ITs swirled and micro-marred, but I dont see where the clear is removed.
If it was on a flat spot, it would look "feather-edged"
On an edge, its dead obvious.
Not true in the case of a single stage paint.
If you burnt through a multi-stage paint with a polisher, there would be no color, you would burn right through it and see primer....
If it was on a flat spot, it would look "feather-edged"
On an edge, its dead obvious.
Not true in the case of a single stage paint.
If you burnt through a multi-stage paint with a polisher, there would be no color, you would burn right through it and see primer....
KnuckleBuckett
New member
You aren't through the clear coat. You just have lots of work yet.
I seriously doubt you could get through the clear coat with an orange pad and a PC without trying to on purpose. It's not like you are using a rotary.
Might try giving the folks at Adam's a yell.
I seriously doubt you could get through the clear coat with an orange pad and a PC without trying to on purpose. It's not like you are using a rotary.
Might try giving the folks at Adam's a yell.