Hello all,
Got a Cam Spray foam cannon today and have a question about the connections, I don't want to force something if I don't need to. I've attached a photo for reference to simplify this a bit.
I'm trying to get this setup with my quickconnect. I'm assuming I'm using the right parts here. Part 2 came with the CamSpray, part 3 is my QC. Am I right in the connection here ? If so, the thread from Part 2 will only go into Part 1 (connection A) about halfway. Is this normal, or should I go ahead and wrench down on it ?
While I have you, I assume this question will answer itself when I get it going, but what does the adjustment of the fan blades (turning the nozzle) accomplish ?
Thanks in advance for the attention!
Regards.
Got a Cam Spray foam cannon today and have a question about the connections, I don't want to force something if I don't need to. I've attached a photo for reference to simplify this a bit.
I'm trying to get this setup with my quickconnect. I'm assuming I'm using the right parts here. Part 2 came with the CamSpray, part 3 is my QC. Am I right in the connection here ? If so, the thread from Part 2 will only go into Part 1 (connection A) about halfway. Is this normal, or should I go ahead and wrench down on it ?
While I have you, I assume this question will answer itself when I get it going, but what does the adjustment of the fan blades (turning the nozzle) accomplish ?
Thanks in advance for the attention!
Regards.