Gurge
New member
Client in question was a victim of Hurricane Sandy. His Scion TC took on water during the storm and was a total loss. In an effort to take lemons to lemonade, he invested his insurance check towards an asphalt gray Scion FR-S. Now thats thinking with your dipstick! (anyone else remember those castrol commercials?)
Upon arrival the car was pretty dirty as we had a recent snowfall. So we started with a foam bath. The wash was followed by Iron x treatment
The car was clayed with Pinnacle Ultra Poly clay. Even for a vehicle only recently purchased it still showed signs of contamination. This is from the trunk lid and rear of the car
Paint measurements were then taken and this car showed a wide range of numbers. Of particular concern was the hood close to the front bumper. This area was thin with readings between 80-90 microns
After taping off the trim it was time for the paint correction. The vehicle showed only light marring and a 1 step polish was in order. With the light defects and metallic paint it was tough to photo accurately.
this area had not yet been polished as shown here under an LED flood light
the adjacent area along the door edge had been polished
Along the roof a sirius satellite radio antenna had been held in place with a magnet. This left behind some deeper scratches which required spot compounding.
before
After
We later relocated the antenna onto the rear glass with double sided tape.
"Hands on the wheel" Polishing under LED lights with Flex 3401, Lake Country Tangerine pad and Menzerna Power Finish
Once the paint was proper it was washed again, dried, and wiped down with Car Pro Eraser. All exterior paint & trim was then protected with Opti-Coat along with the wheels.
Post Opti-Coat
exhaust tip was also was cleaned and protected with Opti-Coat
Crisp reflection of the LED spotlight x3
Extreme closeup on the hood
Proudly serving Long Island and FT86 club!
www.MrSparkleDetailing.com
31 Eads St. Unit #E - West Babylon
You can also stay up to date on whats in the Mr. Sparkle garage by following me on instagram @mrsparkledetailing
Upon arrival the car was pretty dirty as we had a recent snowfall. So we started with a foam bath. The wash was followed by Iron x treatment
The car was clayed with Pinnacle Ultra Poly clay. Even for a vehicle only recently purchased it still showed signs of contamination. This is from the trunk lid and rear of the car
Paint measurements were then taken and this car showed a wide range of numbers. Of particular concern was the hood close to the front bumper. This area was thin with readings between 80-90 microns
After taping off the trim it was time for the paint correction. The vehicle showed only light marring and a 1 step polish was in order. With the light defects and metallic paint it was tough to photo accurately.
this area had not yet been polished as shown here under an LED flood light
the adjacent area along the door edge had been polished
Along the roof a sirius satellite radio antenna had been held in place with a magnet. This left behind some deeper scratches which required spot compounding.
before
After
We later relocated the antenna onto the rear glass with double sided tape.
"Hands on the wheel" Polishing under LED lights with Flex 3401, Lake Country Tangerine pad and Menzerna Power Finish
Once the paint was proper it was washed again, dried, and wiped down with Car Pro Eraser. All exterior paint & trim was then protected with Opti-Coat along with the wheels.
Post Opti-Coat
exhaust tip was also was cleaned and protected with Opti-Coat
Crisp reflection of the LED spotlight x3
Extreme closeup on the hood
Proudly serving Long Island and FT86 club!
www.MrSparkleDetailing.com
31 Eads St. Unit #E - West Babylon
You can also stay up to date on whats in the Mr. Sparkle garage by following me on instagram @mrsparkledetailing
