Mary B
New member
I seen this the other day, a 2ft. Bucket filler.
At 200$ w/ QCs all Stainless. Out of my reach.
He does offer a better priced version. For 30$.
Nice, but somewhat limited in use.
(plus blue won’t match my Zilla green PW set-up
)
I would need it to not impede the use of a PW.
The nozzle should operate 1 handed not 2.
Would like a nozzle to have several spray patterns.
Fill a Foam Cannon bottle at a comfortable height.
So off to HD to try and Mary Rig one.
Several QCs, a 6’ hose, a 5/8” Grip-Lock male hose
mender by Orbit, a wand style nozzle w/ 8 patterns
and thumb controlled, rubberized of course!
Last but not least, an all metal Y connection
for the spigot.
The new QCs had this metal seat valve, that would rest
on the flat inside of the Y connect and the Grip lock.
Actually plugging them.
Here’s a look at an older one, no seat valve.
So, I needle nosed the inside,
Then pulled it free from the front.
Cut my hose, pushed it into the Grip Lock.
Dry assembled.
Everything was good.
Thread taped and put her together.
Fully pressurized, no leaks, correct length. Open spigot
for my PW.
And Quick disconnect wand to fill my Foam Cannon, as many times as needed, at a comfortable height.
Without disturbing the PW set-up.
She breaks down to fit nicely in the drawer of my cart.
:wub:
Sent from my iPad using Tapatalk
At 200$ w/ QCs all Stainless. Out of my reach.
He does offer a better priced version. For 30$.
Nice, but somewhat limited in use.
(plus blue won’t match my Zilla green PW set-up
)I would need it to not impede the use of a PW.
The nozzle should operate 1 handed not 2.
Would like a nozzle to have several spray patterns.
Fill a Foam Cannon bottle at a comfortable height.
So off to HD to try and Mary Rig one.
Several QCs, a 6’ hose, a 5/8” Grip-Lock male hose
mender by Orbit, a wand style nozzle w/ 8 patterns
and thumb controlled, rubberized of course!
Last but not least, an all metal Y connection
for the spigot.
The new QCs had this metal seat valve, that would rest
on the flat inside of the Y connect and the Grip lock.
Actually plugging them.
Here’s a look at an older one, no seat valve.
So, I needle nosed the inside,
Then pulled it free from the front.
Cut my hose, pushed it into the Grip Lock.
Dry assembled.
Everything was good.
Thread taped and put her together.
Fully pressurized, no leaks, correct length. Open spigot
for my PW.
And Quick disconnect wand to fill my Foam Cannon, as many times as needed, at a comfortable height.
Without disturbing the PW set-up.
She breaks down to fit nicely in the drawer of my cart.
:wub:
Sent from my iPad using Tapatalk
