Question on beading, ok when it rains, but almost non existent when rinse after wash

OP. If you are using a dedicated car wash soap then that`s your problem. Instead use Dawn dish soap. Some will claim that Dawn will dry out your seals and ruin the finish on your vehicle but I`ve never experienced this.

Any other questions?
 
If the SDS shows a high percentage sodium cloride (salt) it is there to make the soap appear thicker, and ups the corrosive cleaning, however it often leaves a film on the surface, reducing any beading action.
 
bad penny said:
OP. If you are using a dedicated car wash soap then that`s your problem. Instead use Dawn dish soap. Some will claim that Dawn will dry out your seals and ruin the finish on your vehicle but I`ve never experienced this.

Any other questions?
Click to expand...
Are you a troll?

Sent from my LYA-L09 using Tapatalk
 
ers said:
Thanks everyone for the replies. I think I am going to try either Hyper wash or the optimum.

ERS
Click to expand...

-I would also give my vote to ONR/Optimum.

I might also suggest you give TW ceramic wet wax a shot for a drying aid and to replace the seal and shine. I like both, but for your situation where you are washing and reapplying as often as you are I think you would appreciate the ceramic drying aid. Tough to not give it a shot as cheap as the stuff is!
 
There`s a few things here. Most obvious is that you have the wax from the soap masking the underlying protection. This will happen with any wax shampoo. The suggestion to use dish soap is just stupid.

What I would also add is that the protection regime is massive overkill. The wax is on under the sealant, which is applied every fortnight! Fair enough if it was a quick detailer, but it`s a quite high durability sealant. Overkill. The additional problem is that every additional layer seals in contamination.

Change the soap, use a QD instead of a sealant as a QD and then come spring pick better protection products.
 
Putting a sealant over a wax doesn`t really work, the sealant can not obtain full bonding. It is possible to put a wax over a sealant and expect some usual life of the products.
Went through proving out/lab test back in the early 90`s.
 
My understanding was that for the best results with SnS you need to do at least a light correction. And I haven’t heard of it used as a QD or topper. TW Flex Wax seems to be made for both.
 
You must log in or register to reply here.
Back
Top