CG6Lemon
New member
A longtime and good friend of mine recently acquired a new to him car, which is a 2005 Lotus. He wanted to learn how to clean it up and maintain. I offered him to teach him on a weekend where I was free. He gladly accepted my offer and we set up a day. The car only had a single owner before he bought it so it was in good condition to begin with. After a couple of hours of hard work on his part of course we took it for a drive to get a feel of the car. We took it to some back roads and surprisingly the car`s power to weight ratio feels really good. Had a blast and grabbed some food to catch up and parted ways. Onto the pics....
Started with wheels, applying Hydro afterwards
DetailedByPrecision2795 by Limny Kuang, on Flickr
DetailedByPrecision2803 by Limny Kuang, on Flickr
DetailedByPrecision2799 by Limny Kuang, on Flickr
Followed with foam, clay, iron X. For protection, applied Hydro to all surfaces
DSC_2809 copy by Limny Kuang, on Flickr
DSC_2810 copy by Limny Kuang, on Flickr
DetailedByPrecision2822 by Limny Kuang, on Flickr
DetailedByPrecision2812 by Limny Kuang, on Flickr
DetailedByPrecision2826 by Limny Kuang, on Flickr
Applied Wolfgang Trim Sealant to trim pieces as well
DetailedByPrecision2804 by Limny Kuang, on Flickr
DetailedByPrecision2840 by Limny Kuang, on Flickr
DetailedByPrecision2806 by Limny Kuang, on Flickr
DetailedByPrecision2842 by Limny Kuang, on Flickr
DetailedByPrecision2853 by Limny Kuang, on Flickr
Finished pics:
DetailedByPrecision2833 by Limny Kuang, on Flickr
DetailedByPrecision2837 by Limny Kuang, on Flickr
DetailedByPrecision2836 by Limny Kuang, on Flickr
DetailedByPrecision2835 by Limny Kuang, on Flickr
DetailedByPrecision2830 by Limny Kuang, on Flickr
DetailedByPrecision2843 by Limny Kuang, on Flickr
DetailedByPrecision2852 by Limny Kuang, on Flickr
What I learned from this detail:
Cannot spray water around rear tail lights. The design of it will allow water to seep through and flood the trunk area.
Thanks if you guys read the whole thread. Any comments or input are always welcomed.
Started with wheels, applying Hydro afterwards



Followed with foam, clay, iron X. For protection, applied Hydro to all surfaces





Applied Wolfgang Trim Sealant to trim pieces as well





Finished pics:







What I learned from this detail:
Cannot spray water around rear tail lights. The design of it will allow water to seep through and flood the trunk area.
Thanks if you guys read the whole thread. Any comments or input are always welcomed.