I tried out Z2(ZFX - three coats) for the first time and had a pretty good experience. However, I tried to wipe the car down with Z6 after the first coat, and had a horrible time with it. Streaks everywhere that wouldn't buff out. I ended up with a light distilled water mist and a fresh towel to clear it up before the next coat, and didn't touch the Z6 again after that. The Z sprayer is flat out junk, which doesn't help. I'm considering diluting with distilled water in a better sprayer before giving it another shot. Anyone have any thoughts about this?
Z6
- Thread starter rta108
- Start date
cwcad
New Normal
The first thing that I thought of is that you used to much product to get the streaking. Find a sprayer that you like and try again before you dilute the product. As with almost any Z-line product.....Less is more.
If you feel that you did not use to much product then disregard. There is nothing wrong with diluting. I have mixed 50/50 Z6 to distilled water and still get good results.
I just never have had a problem removing Z6. The only Z-line product that even approached difficult for me was when I applied to much Z2Pro and tried to buff off before it was completely dry.
If you feel that you did not use to much product then disregard. There is nothing wrong with diluting. I have mixed 50/50 Z6 to distilled water and still get good results.
I just never have had a problem removing Z6. The only Z-line product that even approached difficult for me was when I applied to much Z2Pro and tried to buff off before it was completely dry.
G35stilez
Ari Gold
Z6 is very concentrated.
You should need 1 spritz per panel.
What polish did you use before laying down Z?
You should need 1 spritz per panel.
What polish did you use before laying down Z?
Statman
Go Buffs!
Use Z-8 instead...but as the thers have said..you don't need much!