Worried about Products- Any Help?

2

2000TL

New member
I left the following products in the trunk of my car after my last detail a few months ago, and they have endured some intense heat I'm sure since being in there. Do you think they're still "good" and maintain their potency?



VM

Poorboys EX and EX-P

Quikshine

3M FI- Machine Glaze and 3M FI-III RC



Also, when I applied VM, it seemed very "oily" and hard to get off after letting set for a few minutes because it was streaking and still in an oily state. Is this normal?
 
I can understand your concern. It's best to keep your detailing products as close to 70 degrees ( or consistant room temp. ) I'd just give your bottles a good shake for a few minutes & hope for the best. ( by the way, it was 95 degrees here in San Angelo today. It's not even summer yet! YIKES!! )
 
I would test them out on a small section of paint. If they don't work well, then I would be skeptical myself to use them. If they seem to work fine, they probably do.



Dare I complain about the heat here, way up north? Nah...
 
2000TL said:
I left the following products in the trunk of my car after my last detail a few months ago, and they have endured some intense heat I'm sure since being in there. Do you think they're still "good" and maintain their potency?



VM

Poorboys EX and EX-P

Quikshine

3M FI- Machine Glaze and 3M FI-III RC



Also, when I applied VM, it seemed very "oily" and hard to get off after letting set for a few minutes because it was streaking and still in an oily state. Is this normal?
Click to expand...



By all means DO NOT USE!!!!! Box it up immediately and send it to me for inspection and I can dispose of it properly (on my vehicle that is:D ) All kidding aside, I would think it should be okay. I've only used VM by PC and never had any problem with it at all. I assume you shook it up real good before using it as it has always had a tendency to seperate when it sits for awhile.:)
 
Thanks guys, I am gonna try 'em out anyway.



BTW- when using VM, how long should I let it sit after PC buffing it in before wiping it off? And then how long till I can apply the EX?
 
2000TL said:
Thanks guys, I am gonna try 'em out anyway.



BTW- when using VM, how long should I let it sit after PC buffing it in before wiping it off? And then how long till I can apply the EX?
Click to expand...



Bump...
 
2000TL said:
Thanks guys, I am gonna try 'em out anyway.



BTW- when using VM, how long should I let it sit after PC buffing it in before wiping it off? And then how long till I can apply the EX?
Click to expand...



1 last bump...
 
You must log in or register to reply here.
Back
Top