Weird spots on paint

F

fxportapot

New member
Hi I'm new around here and am seeking your help identifying faded/white spots on a black '99 Audi a4 that I bought, the previous owner parked it under a tree for weeks at a time, I am no professional, and seeking pro help is not beyond me but if at all possible I would like to take care of this myself. The spots are only visible from certain angles so pictures were tough to get but let me know what you think!
Thanks!

2012-04-23_1 - Minus
 
Posting in-line for everyone :):

d6lsz2DCNcJVB.jpg


dbqBWxYft23bQS.jpg


Maybe hard water spots? What have you tried to remove them?
 
Those look like paint stains. Depending on the depth of the paint stain you should be able to polish those out. How did you apply the compound (I wouldn't recommend the Turtle Wax kind) or polish? Did you use a machine?
 
I used both a machine and by hand, I was getting a better cut on it by hand I'm going to try a compound with some more grit. I was having a bit of luck tonight but it seems the old Audi has some pretty tough/hard paint.
 
You might want to use a yellow pad with 105 amd go slow at it, 2x2 area first to see want you done, but it looks like the stains are in the paint IMO.
 
I was using a wool pad on my orbital, I just ordered a yellow and an orange pad from autopia car care, so I'll give it another shot in a few days when the pads come.
Thanks!
 
I had a junk orbital from Walmart, I also had a sears gift card burning a hole in my pocket so I now have a pc 7424 on the way, if it works to correct the issue great , if not I'll detail the wife's car.
 
so the hood turned out pretty good, not done yet but I got the spots out


In other news the fender may be a lost cause, you can see in the first picture where my tape was and how heavy the oxidation/spots are, either the oxidation is super heavy and tough to get through or I burned through the clear to get past the oxidation,... thoughts?




this was done with m105, a pc7424, and a LC yellow and orange
 
:welcome: To Autopia Forums!

Paint correction and detailing are hard work and take tome to do it correctly. Work each panel until you're satisfied with the result then move on.

I think what may have happened initially is it sounded like you used a wool pad on on a dual action polisher and this typically doesn't yield great results.

Keep up the good work! :bigups
 
Great you got the spots out!Looks great.:bigups

If you havent already make sure to get the compound slatter cleaned up ,it can stain and/or be a bear to get off later .

You also may want to check your work out in the sun to see how it looks . You may need to use a polish to finish up ,especially on a dark color like black.
 
You must log in or register to reply here.
Back
Top