budman3
Detail time!
I’d like to start this post off by saying thank you to cwcad for helping me figure out the Zaino system. Everyone knows that Zaino is talked about a lot but there is very limited helpful information about the products so cwcad helped me out a lot. This is my first time using Zaino and I figured I’d see what all of the hoopla is about. I received a bottle of Z1 and Z5 from another member and put them to work on this detail. This Corolla belongs to my girlfriend and winter had taken its toll on the car. Back in January or February we did PwS with a light cut pad topped with EX-P and was due for a detail. Salt and a bad snow brush left some nice swirls for me to remove with the UDM. There is still a few deep swirls on the hood and trunk lid which we’ll have to live with.
Process:
Wash
Spot clay
SSR2.5 (UDM, polishing pad, speed 6)
SSR1 (UDM, polishing pad, speed 6)
Alcohol wipedown
Z1
Z5 x2
I did the second coat of Z5 the day after and I was planning on adding another but the weather didn’t hold up. I did this detail last week but my time and weather held off this post until today when I finally got some decent pictures. Hope you enjoy.
Before:
Swirling:
Afters:
Water beading the day after:
Process:
Wash
Spot clay
SSR2.5 (UDM, polishing pad, speed 6)
SSR1 (UDM, polishing pad, speed 6)
Alcohol wipedown
Z1
Z5 x2
I did the second coat of Z5 the day after and I was planning on adding another but the weather didn’t hold up. I did this detail last week but my time and weather held off this post until today when I finally got some decent pictures. Hope you enjoy.
Before:


Swirling:


Afters:








Water beading the day after:

