Might be a minute detail and perhaps even the ocd in me coming out, however I decided to purchase a can of Sonax netshield and the exterior packaging wrapper is different than any other I have seen, see the attached photos, first is the typical can, the second is the one I received. Do I have old product or what? Anyone can shed light thanks, I am sure its not a big deal just wondering.
Sonax Polymer Netshield packaging difference between bottles?
- Thread starter nls8520
- Start date
RaysWay
Autopia Specialist
I just tweeted @Sonax_USA your question: https://twitter.com/AutogeekRay/status/500538681388990464
I've tweeted them before and they've always replied quickly. Let's see what they say...
I've tweeted them before and they've always replied quickly. Let's see what they say...
Stokdgs
dansautodetailing.com
I am positive that you have the newer packaging, because the can on the left is the same I purchased at least 3 years ago..
This is a really great product that totally rocks paint that has been corrected and cleaned.
Have read as you probably have too, that it has been successfully used over sealants and coatings as well.
It has always applied a little "grabby" on German paint which is what I do the most, and you need to just do a little section and wipe it off, and then go to the next section..
You will always be able to tell where you left off because once it is on and wiped off, it is not grabby and a reapplication just glides on..
I used a small yellow circular foam sponge and after awhile, there was enough on the sponge so I didnt need to spray it very much to apply preceding panels..
Dan F
This is a really great product that totally rocks paint that has been corrected and cleaned.
Have read as you probably have too, that it has been successfully used over sealants and coatings as well.
It has always applied a little "grabby" on German paint which is what I do the most, and you need to just do a little section and wipe it off, and then go to the next section..
You will always be able to tell where you left off because once it is on and wiped off, it is not grabby and a reapplication just glides on..
I used a small yellow circular foam sponge and after awhile, there was enough on the sponge so I didnt need to spray it very much to apply preceding panels..
Dan F
SGM2008
New member
I have both. The can with the predominately red label is the newer of the two.
The red labeled can is also depicted on the Sonax USA website so I think you can rest easy!