Quick detailing as an alternative to washing

I

imported_Indy YZF

New member
At http://www.autopia-carport.com/Detailing-Articles/Washing.htm David says quick detailing is a good alternative to washing, to lessen the amount of washing that needs to be done...Maybe MF allows wiping with water and quick detailers to NOT scratch the surface of a dirty car, but is this something to be afraid of? I like the idea of 'washing ' this way without shampoo, but, i thought it was a sure way to scratch the surface...Is it the MF cloths which allows us to wash this way safely?
 
Hi paul e,



I think David meant, if your car has light dust on it. If you have a daily driver and have not washed it for a week then, a quick detail is not an option. If you do a quick detail say 1-2 days after you wash your car then it's ok. The reason why micro fiber cloths are superior over cotton cloths is that they have interval spaces between the fibers that will allow dust to be trapped in the cloth. Unlike, cotton cloths where there is very limited area where dust can be trapped so the dust is rolled or pushed over the surfaces which case in point will more than likely causes scratches. Micro fiber towels minimizes these chances. Remember, quick details are great for light dust on the car but a no no when there is dirt. And use a micro fiber towel.



Aloha,

~Ranney
 
Hi paul e,



Using a Cal Duster will actually be worse than using a quick detail spray and a micro fiber towel. I personally, think a quality quick detail spray like Zaino Z6, Meguiar's Final Inspection, or One Grand Show Off and a quality micro fiber towel will be the best route. The Cal Duster does not lock dust or dirt, it just gets stuck and is rubbed back and forth your paint. Definitely will scratch your car and cause swirl marks. You are welcome to try the Cal Duster but don't tell me I didn't warn you....:nixweiss



Aloha,

~Ranney
 
Meguiar's Final Inspection after using the CA Car Duster has been part of my car care for at least 10 years. If there has been only dust acumulation with no moisture, it works quite well for me. Car Duster each day and Final Inspection after about the third day. When I have time, Final Inspection every day.



Charles
 
paul e said:
Hell, for just dust, its a hell of a lot easier to gently wisk a Cal Duster over the surface, isnt it?
Click to expand...



I would recommend using a CCD as part of your QD routine anyway. The Duster will safely take away the dust, but afterwards, you should spray some QD on your car and buff to a shine if you really want to make a difference.
 
Hi, Paul e



Don't know where you're located , but here in Belgium it's quite simple : you allmost never QD : too much dust and industrial fallout.

The only times I QD is in between Z-ing and a single time the day after I washed the car to get MINOR dust off.



Better safe then sorry , that's my motto!



Recently I've been on a campingtrip with my Cabanon campingtrailer, the campingspot was only 130 miles away , but by the time I got there the front of the car was a bug-graveyard:mad:

When the evening came and the car cooled down , the only option was to remove the bugsplatters before they baked in , I did this with a home-prepared spritzbottle with Z-shampoo and water, they came off real easy!!!:up



I did clean-up the spot after that with QD.



OT: as I arrived on the campingspot , my neighbour there congratted me with my new car.He could hardly beleive that it was 14 months old...
 
I basicly spray my black Cobra off at the manual car wash once a week.Hand wash once or twice a month. (depending on time of year) Spring means pollen-summer means dust-fall means leaves, winter means it's going to be covered most of the time. The Cal Duster is OK for minute dust...but I don't use it to "clean." I only use QD after it is clean. I never let the dust or dirt acumilate. If I can't get it clean by spraying at the car wash, I's too dirty and needs hand washing. Also interstate driving is usually worsre than "around town" If you spray your vehichle off and your drying towel or shammy is getting dirty, you need to hand wash. That's why a good SG is important. I agree with Pakshak about the CD. It more times than not just pushes the dust and dirt. My main fear about QD to clean is that you are to some exstent "rubbing the dirt into the paint" The CD & QD main purpose for me is on my already clean paint. If I go to a car show, my paint is already clean, I just continue the use the CD, QD & a MF cloth through out the day to maintain my cleanliness and shine. I never just wake up, go out and jump on it with a QD & towel."showroom has a good theory.....when in doubt......WASH!

It's just what works for me:down
 
PakShak said:
Hi paul e,



Using a Cal Duster will actually be worse than using a quick detail spray and a micro fiber towel. I personally, think a quality quick detail spray like Zaino Z6, Meguiar's Final Inspection, or One Grand Show Off and a quality micro fiber towel will be the best route. The Cal Duster does not lock dust or dirt, it just gets stuck and is rubbed back and forth your paint. Definitely will scratch your car and cause swirl marks. You are welcome to try the Cal Duster but don't tell me I didn't warn you....:nixweiss



Aloha,

~Ranney
Click to expand...

The Cali Duster will NOT cause surface marring if used properly and for the appropriate situation. For light dust it should be used prior to Qd'ing with a MF or good cotton towel. These items should be used in tantum. Spraying QD on a dusty car and wiping with anything is just another form of "wet sanding" :scared. You can use a MF to initially remove dust but the Cali duster is better suited for the job and more efficient ( less contact time on finish).

If in doubt ... WASH!! A dirty swirl-free finish always looks better than a clean marred finish. At least to this Autopian.
 
If useing a Cali duster just remember that the paint surface must be COOL. A hot surface will make it scratch easier.
 
I use my old cali duster for cobwebs i cant reach in the garage

I think that is what it is best suited for

IMO of course

Sent from my SM-G900P using Tapatalk
 
EXPDetailing said:
So, are you against waterless washes and Rinsless washes?
Click to expand...
I used his wet sanding method at 330pm on paint so hot i felt it through the towel earlier today with qd+ and a DMMT
Worked for me, lol

173c1a5a09c0456ae0cbf8206a3287cf.jpg



21b5848918b42f4f637089b45aa9c200.jpg


Guess that`s part of the epic nature of this thread :)

Sent from my SM-G900P using Tapatalk
 
If I use a CCD I mar paint. Period. Might not happen every time, might not happen to an obvious degree. But eventually it happens and I can see it under the right conditions even if nobody ever notices it in Real Life.

I don`t QD between washes for the same reason.

If other people are happy doing such stuff I won`t try to change their ways, but it`s not just a matter of "doing it properly"; there are only so many user-influenceable factors involved and I`m utterly confident that I`ve done those things "properly". But if I turn out all the lights and spend time with the SunGun, I see marring. You cannot move abrasive dirt across paint under too much pressure without causing marring and that`s exactly what happens (sooner or later) when I do things like CCD/QD.
 
You must log in or register to reply here.
Back
Top