OCW or Aquawax over NXT

gofastman

New member
AW or OCW to boost NXT after washes?

I know about NXT booster wax, it works well and I like it, but I want something faster, a WAUD type product.

Sugestions?

Thanks
 
Done both, both work fine. I tend to have only a little water on the surface though.. OCW typically hasn't done all that great if the surface is just soaked. For instance, I normally sheet with the nozzel off then lightly run a ww over the surface, then clean up the remaining moisture with OCW/AW and a plush mf.
 
both AW and OCW are WAUD products, right?



For what its worth I'm mostly doing ONR washes, so I dont think pooling water is a problem
 
NXT Paste topped with AW on a 10yo legacy

hood.jpg
 
AW works best after drying ..it can be used on a wet car..but the results are best doing after you dry...and a little goes a long ways....do not over spray ....1 spray per panel good...wipe in with one MF and wipe off with another dry one...spray a panel wipe it in..and buff off with a dry side..



AL
 
FWIW, I've had no problems using AW on a slightly wet surface... I get no hazing, streaking, etc. I use the same amount as I would on a dry panel. This stuff is almost fool-proof. I will admit that I think OCW gives a little bit more depth to the finish, most likely due to the slight carnuaba content, but for the money, AW is a steller product.
 
AL-53 said:
AW works best after drying ..it can be used on a wet car..but the results are best doing after you dry...and a little goes a long ways....do not over spray ....1 spray per panel good...wipe in with one MF and wipe off with another dry one...spray a panel wipe it in..and buff off with a dry side..



AL



I agree, either AW or OCW should work fine over NXT, but be sure to use it on a freshly dried car. I'd recommend getting a "mister" type spray head for your bottle, it really helps you to use less product, yet, it still allows you to cover a larger area.



I really like these spray heads:



Heavy Duty Industrial Sprayer
 
Back
Top