Well I decided to clean up the GF's car while she was out of town. I'm looking to winterproof it with AIO/SG/P21S and at this point I've got everything masked off and gone over it once with a PC and the AIO.
My problem is I'm thinking perhaps I didn't take enough time making sure I had a perfectly clean surface to work with during the claying stage, particularly on the back of the car which tends to build up a lot of layered dirt. The reason I say this is the white pad I use for the AIO came away reasonably dirty after going over the car once.
Now I haven't noticed any marring or anything but I can't escape the lingering feeling that it's not 100% clean and I don't want to be sealing crap inside the SG.
Basically I'm trying to figure out where to go from here... I could spot clay the back, behind the wheels etc, then hit those specific areas with the PC again and go from there. I could just pull all my tape off (/cry) and start over again (This option pains me since I've already sunk a good chunk of time into the car and masking all the plastic moulding on a mini is a huge PITA). I could chalk it up to me being overly obsessive and just move on with the process and hit it with the SG.
Opinions?
My problem is I'm thinking perhaps I didn't take enough time making sure I had a perfectly clean surface to work with during the claying stage, particularly on the back of the car which tends to build up a lot of layered dirt. The reason I say this is the white pad I use for the AIO came away reasonably dirty after going over the car once.
Now I haven't noticed any marring or anything but I can't escape the lingering feeling that it's not 100% clean and I don't want to be sealing crap inside the SG.
Basically I'm trying to figure out where to go from here... I could spot clay the back, behind the wheels etc, then hit those specific areas with the PC again and go from there. I could just pull all my tape off (/cry) and start over again (This option pains me since I've already sunk a good chunk of time into the car and masking all the plastic moulding on a mini is a huge PITA). I could chalk it up to me being overly obsessive and just move on with the process and hit it with the SG.
Opinions?
