Motorcycle detailing -fast?

[frito]

I run a motorcycle shop and want to get our used bikes looking the way I would expect as a potential customer.



I read the $100 solutions thread and see that the HF unit may be a good choice. I am unsure of the backing plate and pad size. I am thinking I may need 4"-5" or so to get around tight spaces. Perhaps two backing plates and pads?



I normally use M105 and M205 but if there is a good one step that we can get good results it would likely end up with a better result (attention span of my employee).



Any help would be greatly appreciated.

 

[togwt]

Wash with an ONR solution and then use a one-step polish (Menzerna PF 2500 – Power Finish Polish (PO203) finish off with a WOWO spray (Dodo Juice Red Mist Tropical Spray Detailer)

 

[frito]

Wash with an ONR solution and then use a one-step polish (Menzerna PF 2500 – Power Finish Polish (PO203) finish off with a WOWO spray (Dodo Juice Red Mist Tropical Spray Detailer)

Thank you very much. I see your related threads and I will read them all.

 

[Merlin]

For a fast bike wash I like the Mr Clean Auto Dry...MC-AD, a wash mitt & a blow dry and you're pretty much good to go.

Wheels that have crevice build up are pain. Spray with S100 total cycle cleaner wait 2 min Use a wheel brush and rinse.



For a two step correction I like using Megs D300 with a 3" or 5" microfiber cutting disc followed with LC white and M205.

For a (very close) to a 1 step polish I've had good luck with LC orange/white foam pads & M101 using only a DA machine.