Dust Removal Between Applications

W

wvs16

New member
I'm curious as to how everyone removes any dust that settles on the car between applications. For instance, if I plan to use AIO then top it with Souveran 2X, this will be done over the course of 3 days to allow curing for each step.



The car would be in a clean garage without a lot of dust. But there is a chance for dust to settle on the car during this time.



I don't think you would wash the car each day before the next product application. Do you use a California Duster? My car is black so I want to be careful. Thanks for any suggestions.
 
Hello wvs16,



If its just dust, i use my CCD *very lightly* and then S&W. However, if there's some "3-dimensional" dirt spots (bird bombs, mud, squashed bugs, etc.), I usually wash.



I have black car and was worried about marring, but I have not found any...I must emphasize that extremely light pressure was used with the CCD.



MCA
 
wvs16,

Just went thru the same situation. Didn't drive the car between applications, but even keeping the garage doors closed I still had a bit of dust settle on the car. I just used some Meg's Final Inspection on a microfiber; seemed to work fine.
 
You must log in or register to reply here.
Back
Top