This truck received a new paint job, but the finishing work left much to be desired. There were some light rotary holograms, and I have never seen so much overspray on any vehicle. The hood was especially bad - felt worse than sandpaper. Because of this, the paint was pretty dull and life-less. I think the owner and I were both pleased with the outcome.
Interior:
Vacuum
Light steaming
Exterior:
Simple Green 1:3 for wheels/tires/wells
Meguiar's NXT wash
Zaino Z18 clay (took the whole bar)
Pinnacle XMT 3 Intermediate with light cutting pad via PC - speed 6
Werkstatt Prime Strong with polish pad via PC - speed 5
Werkstatt Trigger by hand
Armor All in wells
Zaino Z16 for tires and trim
Sprayway on glass
Hood Issue:
Clayed x 3
Prime Strong with light cutting
XMT 3 Intermediate with light cutting
Menzerna PO106FF with polishing
Prime Strong with polishing
Pictures:
Questions/Comments always welcome.
Interior:
Vacuum
Light steaming
Exterior:
Simple Green 1:3 for wheels/tires/wells
Meguiar's NXT wash
Zaino Z18 clay (took the whole bar)
Pinnacle XMT 3 Intermediate with light cutting pad via PC - speed 6
Werkstatt Prime Strong with polish pad via PC - speed 5
Werkstatt Trigger by hand
Armor All in wells
Zaino Z16 for tires and trim
Sprayway on glass
Hood Issue:
Clayed x 3
Prime Strong with light cutting
XMT 3 Intermediate with light cutting
Menzerna PO106FF with polishing
Prime Strong with polishing
Pictures:
Questions/Comments always welcome.
