cutting and polishing process???

[imported_Time2shine]

Try the M205 first, it may just get the job done.

Yeah i plan on using the 205 with an orange pad or should i use a different pad first? I currently have on hand 2yel, 2org, 2wht, 1blue and 1blk all LC flat 5.5

 

[imported_Time2shine]

Have a spray bottle of water to extend the working time if necessary.

Should i just give the pad a spray or two?

 

[Nth Degree]

Should i just give the pad a spray or two?

A light mist is all it takes. Either on the pad or directly to the working area, which is what I do when working with my PC. Too much water and it will start to sling.

205 on an orange pad will be a good starting point. I have had great results with that on soft paint, but it will still probably need a follow up with a softer pad for a good finish. (I followed up with Menz 85rd on a black car and it came out fantastic.) If that is close, but not quite enough, I would try 105 with white pad. But if it is not even close to enough, then it will take 105 on orange. Go slow at first with this (light-med pressure and short work time and check often) until you get a feel for how it's working. No need to take off more clear than necessary.

 

[imported_Time2shine]

Thanks everyone for the helpful info, i will be putting it to good use very soon.