Best product for use after DACP?

N

ncsu602

New member
I've been working on my black Camaro and can't seem to get rid of the haze left by DACP. I've been using #9 v2.0 for two passes and I'm not sure if I'm not using it right or I need something a little stronger. I used both with Meg's polishing pads. Do I need to use a different pad, make more passes, or use something a little stronger? What I've done so far looks great until I put it under a halogen lamp. There's very minor swirling, but I can still see a little.



I've got Natty's blue and RMG on the way in the mail, will the RMG take care of this? Thanks!
 
Im not sure the RMG will take care of what DACP leaves behind. Vanilla Moose would be a better Clearkote product. A great Megs product to follow up with would be #80, stronger then #9.
 
This is what ebpcivicsi used on a black porsche detail



3M PI-III MG (THANK GOD for this product, it was the ONLY product that would remove the haze left from the DACP without further micromarring, I will NEVER be without it) via cyclo with green polishing pads
Click to expand...
 
The PI-III MG 05937 (which I *really* like) is getting hard to find. Meg's #80 is sorta the standard answer to "what after #83" and is just right in most cases (that Cayenee ebpcivicsi did was a weird case of very soft paint, your GM is almost certainly a lot harder than that).
 
There's two or three 3M dealers in my area as well as a Meguiar's dealer. I'm guessing the #80 is cheaper, but what would be the best choice given I could get both?
 
You must log in or register to reply here.
Back
Top