imported_Totoland Mach
New member
I did this car in lots of heat and humidity! Scottwax...I still don't know how you do it Sir... but, then again, I'm in my mid 60's and have to watch my blood sugar levels...so maybe that's a factor.
Anyhow, this was a pretty dirty car and had plenty of light swirls and loads of brake dust. I used a full bottle of Meguiar's Hot Rims cleaner for the wheels and neutralized the product with soapy water.
Next up was the interior before the temp rose to the high 90's. I could do the body work in the garage, but I like to get the interior outside to see better. I used my "secret" mix of APC + dishwashing liquid + water (diluted approx. 10-1) and a boar's hair brush to clean and terry towel to remove. I also tried a new vacum by Ridgid: it's about the size of a small portable generator, very light, and all the cords and attachments fit inside. Very nice portable unit and also has a reverse blower.
On to the body: I used Menzerna IP and 106ff to get the paint in good condition. For this leg of the journey, I had my Festool on Rotary mode with a Meguiar's 8006 pad.
Finally, I used the Festool in random orbit and Pinnacle XMT 360. Great stuff that works as advertised and leaves a nice sealant.
Start to finish was just under 8 hours with tons of water breaks!
Toto
Anyhow, this was a pretty dirty car and had plenty of light swirls and loads of brake dust. I used a full bottle of Meguiar's Hot Rims cleaner for the wheels and neutralized the product with soapy water.



Next up was the interior before the temp rose to the high 90's. I could do the body work in the garage, but I like to get the interior outside to see better. I used my "secret" mix of APC + dishwashing liquid + water (diluted approx. 10-1) and a boar's hair brush to clean and terry towel to remove. I also tried a new vacum by Ridgid: it's about the size of a small portable generator, very light, and all the cords and attachments fit inside. Very nice portable unit and also has a reverse blower.


On to the body: I used Menzerna IP and 106ff to get the paint in good condition. For this leg of the journey, I had my Festool on Rotary mode with a Meguiar's 8006 pad.


Finally, I used the Festool in random orbit and Pinnacle XMT 360. Great stuff that works as advertised and leaves a nice sealant.


Start to finish was just under 8 hours with tons of water breaks!
Toto