adams new paint sealant

classofshine said:
Spray 1 section then move to the next, you may get a little over lap. Just hold the spray closer to the surface and you wont get much overspray.
Click to expand...

You may be right but I think I'll pass. Although I can see where it would come in handy holding it close for doing grills and stuff like that were a spray can get in all the tight areas.
 
rzatch said:
There's no way your not going to get overspray on areas you've already done, even indoors. The stuff comes out in a fog.
Click to expand...

The overspray is no big deal. It works fine on trim or glass, just wipe it in. It does not affect vision when applied to glass, even in direct sunlight. It will darken trim and improve the look, but does not last long.
 
rzatch said:
You may be right but I think I'll pass. Although I can see where it would come in handy holding it close for doing grills and stuff like that were a spray can get in all the tight areas.
Click to expand...

You never know until you try, buy some and tell me know it worked out for you.:lol2:
 
It's a nice product, but the fumes can be irritating (cough..cough). So, I only spray it directly on the car in hard to reach areas or close up (minimizing fumes), otherwise I spray it on the applicator.
 
Greg Nichols said:
do we really need another sealant, that is likely a knock off of another manufactor anyways? Do something different, raise the bar, be a game changer or don't release.

Cheers,
GREG
Click to expand...

Who's aerosol spray sealant did they knock off?
As far as your challenge to do something different, and raise the bar, if we held all mfr's to that standard we would have a lot fewer products buy.
 
You must log in or register to reply here.
Back
Top