DetailsByDennis
New member
The Process...
Exterior:
1. Rinsed down the wheels
2. Sprayed down the wheels with Megs Wheel Brightener cut 4:1
3. Brush and cleaned the wheels (boar's hair)
4. Rinsed down the wheels
5. Filled the bucket with water (one rinse one suds) (2 bucket method)
6. Filled the foam gun and soaked the car (let lather for 5-7 min)
7. Shmitt was used for the wash
8. Thoroughly rinse
9. Pulled into garage to clay (clay using Sonus green - and Prima "Slick" detail spray)
10. Car is clayed and dried (dry using WW)
11. Menzerna 106FF @ 1500-1600 to polish out any imperfections (some marring and swirling all over in the same amounts)
12. Headlights and tails were polished using ZAIO (zaino-all-in-one)
13. Exhaust tips got Adams metal polish #1
Interior:
1. Wiped down the door jambs with Prima "Slick" detail spray
2. Vacuumed the entire interior
3. Wiped down the interior and used Z9 and Z10 on the seats
4. Wiped down the dash with a MF towel
5. Cleaned the glass (Stoners IG)
Engine:
1. Rinse with pressure washer
2. Megs APC cut 4:1
3. Rinse again
4. Dry using leaf blower and MF WW
5. 303 Aerospace protectant to all plastics/hoses etc.
Befores:
Check out the SUDS in action!
Afters:
Exterior:
1. Rinsed down the wheels
2. Sprayed down the wheels with Megs Wheel Brightener cut 4:1
3. Brush and cleaned the wheels (boar's hair)
4. Rinsed down the wheels
5. Filled the bucket with water (one rinse one suds) (2 bucket method)
6. Filled the foam gun and soaked the car (let lather for 5-7 min)
7. Shmitt was used for the wash
8. Thoroughly rinse
9. Pulled into garage to clay (clay using Sonus green - and Prima "Slick" detail spray)
10. Car is clayed and dried (dry using WW)
11. Menzerna 106FF @ 1500-1600 to polish out any imperfections (some marring and swirling all over in the same amounts)
12. Headlights and tails were polished using ZAIO (zaino-all-in-one)
13. Exhaust tips got Adams metal polish #1
Interior:
1. Wiped down the door jambs with Prima "Slick" detail spray
2. Vacuumed the entire interior
3. Wiped down the interior and used Z9 and Z10 on the seats
4. Wiped down the dash with a MF towel
5. Cleaned the glass (Stoners IG)
Engine:
1. Rinse with pressure washer
2. Megs APC cut 4:1
3. Rinse again
4. Dry using leaf blower and MF WW
5. 303 Aerospace protectant to all plastics/hoses etc.
Befores:
Check out the SUDS in action!
Afters:
