Recent content by danlc95

I enjoyed you Duragloss posts. I'm in Rochester Hills / Shelby Twp.

It sounds like some of the 2000 grit might not being refined down enough. I've found that when correcting sanding marks with (in my case) a Porter Cable random orbital, I need to make sure the more aggressive sanding marks are refined before proceeding. If it's the hologram / swirl effect...

I just sold one of my Rupes kits, with the other heading to Ebay this week. I prefer the Porter Cable. I haven't been all too swayed by perceived/experienced increase in performance. I think having a 7424xp and a 3401 set up again would fit me better. Back to basics. Apologies to the OP.

I'd give 3D AAT502 a shot. Fermani gave me some HD Polish samples around 2017, and I can't really remember much about using them other than I used them with a Flex PE14 and blue hex logic pads. I remember it smelled great at first, then took on a "rubbery" aroma as it was worked. No big deal...

In the late 00`s, Lake Country released a line of closed cell, European prepolymer foam pads. The intent was to limit product absorption and increased performance as it pertains to the range of function each pad had. For example the heavy cutting Cyan finishes down virtually wax ready, and the...

Hi everyone. I'm very new to this forum, but I can see that there are many experienced detailers. For those familiar with Zymol's product line, I was wondering why Zymol Royale has both blue, and white waxes side by side in the same container? Is one intended to be applied after the other?